HC
2866776
delivery time: in stock
environmental conditions
Protection class IP20
Ambient temperature (operating) -25 °C ... 70 °C (> 60 °C Derating: 2,5 %/K)
Ambient temperature (commissioning type test) -40 °C
Ambient temperature (storage/transport) -40 °C ... 85 °C
Maximum allowable relative humidity (operating) ≤ 95 % (at 25°C, non-condensing)
Climate class 3K3 (according to EN 60721)
Pollution degree 2
Installation height 6000 m
Rated input voltage range 100 V AC ... 240 V AC
Input voltage range 85 V AC ... 264 V AC
90 V DC ... 350 V DC
Dielectric strength max. 300 V AC
AC frequency range 45 Hz ... 65 Hz
DC frequency range 0 Hz
PE discharge current < 3.5 mA
Power consumption 5.1 A (120 V AC)
2.3A (230V AC)
4.9A (110V DC)
2.4A (220V DC)
Rated power consumption 569 VA
Impulse surge current < 20 A
Grid buffer time > 32 ms (120 V AC)
> 32 ms (230 V AC)
Input fuse 12 A (slow blow, internal)
Recommended input protective circuit breaker 10 A ... 16 A (AC: characteristics B, C, D, K)
Power factor (cos phi) 0.89
Protection name Transient surge protection
Protection Circuits/Components Varistors
Rated output voltage 24 V DC ±1 %
Setting range of output voltage (USet) 18 V DC ... 29.5 V DC (> 24 V DC, stable capacity limited)
Rated output current (IN) 20 A (-25 °C ... 60 °C, UOUT = 24 V DC)
POWER BOOST (IBoost) 26 A (-25 °C ... 40 °C constant, UOUT = 24 V DC)
Selective Fusing (ISFB) 120 A (12 ms)
Attenuation 60 °C ... 70 °C (2.5 % / K)
Parallel Yes, for redundancy and increased capacity
Concatenation is
Feedback voltage resistance max. 35 V DC
Overvoltage protection (OVP) at the output < 35 V DC
Control deviation < 1 % (change in load, static 10 % ... 90 %)
< 2 % (change in load, dynamic 10 % ... 90 %)
< 0.1 % (variation of input voltage is ±10 %)
Residual Wave < 30 mVSS (nominal)
Output power 480W
Typical response time < 0.6 s
Maximum idle power consumption 8 W
Maximum rated load power loss 40
Net weight 1.7 kg
Efficiency > 93 % (230V AC and nominal)
MTBF (IEC 61709, SN 29500) > 900000 h (25 °C)
> 520000 h (40 °C)
> 235000 h (60 °C)
Insulation voltage input/output 4 kV AC (type tested)
2 kV AC (routine test)
Insulation voltage input / PE 3.5 kV AC (type test)
2 kV AC (routine test)
Insulation voltage output / PE 500 V DC (routine test)
Protection class IP20
I Mounting position Horizontal DIN rail NS35, EN60715
Assembly instructions Can be installed side by side: PN ≥50 %, 5 mm horizontal spacing, 15 mm spacing if there are dotted parts, 50 mm vertical spacing
Side-by-side installation: PN <50 %, 0 mm horizontal spacing, 40 mm vertical top and 20 mm bottom vertical
