DWCT
Italy Kanglush Cylinder Product Description
The type of the cylinder is integral and single cast.Single casting type is divided into dry type and wet type two kinds.When cylinder and cylinder block are cast into a whole is called integral cylinder; when cylinder and cylinder block are cast respectively, single cast cylinder cylinder is called cylinder sleeve.The cylinder sleeve in direct contact with cooling water is called wet cylinder sleeve; no direct contact with cooling water is called dry cylinder sleeve.
Italy Kanglush Cylinder Product Description
performance parameter:
The 27 series is designed to reduce the cylinder size as large as possible.These cylinders are used both using stainless steel to clean line tubes and rods and aluminum for the end block.
The selection of materials and other design features allow for the creation of a wide range of versatile and reliable cylinders.
Accurate ways to ensure safety tube-to-end blocks ensure that all components are aligned.
Mechanical buffering has been installed on these cylinders to reduce the noise block from the piston impact.The cylinder series 27 is suitable for magnetic assembly sensors.
Various mounting bracket accessories enable the cylinder to be installed to accommodate a required special application.
Material aluminum alloy end cover, stainless steel piston rod and cylinder, nititrile rubber seal, polyurethane rod seal
Installation mode: scaffold, ear shaft, ear shaft support
Travel of 10 1,000 m m
Cylinder diameter 20,25,32,40,50,63 mm
Operating temperature 080°C (dry air is-20°C)
Working pressure of 110 bar
Speed 10 1000 mm/s (no load)
Medium is clean for air, without lubrication.If oil mist lubrication is used, apply uninterrupted (ISO VG32 is recommended)
