DWCT
Specifications detailed
contents of a project
Ordering product No. FX-102P-CC2
Model # FX-102P-CC2
Power supply voltage 12~24V DC ± 10% pulse P-P below 10%
Power consumption normally: below 720mW (supply voltage at 24V, consumption current below 30mA)
In ECO mode: below 600mW (supply voltage at 24V, consumption current below 25mA)
Output a PNP open-circuit collector transistor
Source current: 100mA
External voltage: below 30V DC (between output and + V)
Remaining voltage: below 1.5V (when the source current is 100mA)
Output: The output action can be switched to SET mode when ON / ON
Output: short-circuit protection equipment
External input The PNP has no contact input
Signal conditions
High: + 4V~ + V DC (inflow current 0.5~3mA)
Low:0~+0.6V DC or disconnected
Input impedance: about 10 kΩ
Reaction time lighting frequency below 1:2.5ms (factory status)
The light projection frequency is below 2:2.8ms
The light projection frequency is below 3:3.2ms
The light projection frequency is below 4:5.0ms
Sensitivity setting method 2-point instruction / qualification instruction / fully automatic instruction
Operating status indicator orange LED (lit on output ON)
A 4-bit (green) + 4-bit (red) LCD display is shown
Set the sensitivity fine-tuning function is equipped
Timer function on delay timer / disconnect delay timer adjust valid or invalid
[Timer time: 1ms, 5ms, 10ms, 20ms, 40ms, 50ms, 100ms, 500ms, 1,000ms]
3 Level + automatic setting (from parts produced in December 2007)
Anti-interference function equipment can be adjusted, effective or ineffective
Environmental resistance: use ambient temperature-10~ + 55℃ (4~7 close to installation: -10~ + 50℃, 8~16 close to installation: -10~ + 45℃) (note non-condensation, icing), storage: -20~ + 70℃
Environmental resistance: use the ambient humidity of 35~85%RH, and the storage time: 35~85%RH
Environmental resistance: Use environmental lighting degree incandescent lamp: receive light surface illumination degree below 3,000Rx
Environmental resistance: voltage resistance AC1,000V 1 minute between all power connection terminals and housing
(Note): The voltage resistance and insulation resistance values are only suitable for single amplifier units.
Environmental resistance: insulation resistance between all power supply connection terminals and housing, above 20M, DC250V-based high resistance meter
(Note): The voltage resistance and insulation resistance values are only suitable for single amplifier units.
Environmental resistance: vibration resistance frequency 10~150Hz double amplitude 0.75mm X, Y and Z direction for 2 hours each
Environmental resistance: impact resistance acceleration 98 m/s2 (about 10G) X, Y and Z direction 5 times each
Optical projection element (modulated) red LED (optical projection peak wavelength: 643nm)
Material shell protection cover: polycarbonate
Key switch: polycarbonate
Optical fiber lock rod: PBT
Connection mode The connector connection type
(Note): No "-CC2" at model name does not have connector cable (CN-14A-C2).Be sure to use another connector cable CN-14A (-R) -C □, connector CN-14A or Japanese connector (contact: SPHD-001T-P0.5, enclosure: PAP-04V-S).
The distribution length of the cable above 0.3mm2 can be extended to 100m
Weight Body weight: about 15g
Packaging weight: about 75g
Annex CN-14A-C2 (with connector cable, 2m long): 1
